上海供应PET丝印油墨-PS丝印油墨-PC丝印油墨-ABS丝印油墨-

详细信息

联系方式

PET-9100油墨油墨特性：主要用于PET、PC、不干胶PET、镀铝膜贴花等材料，具有高附着力、高耐折、哑光效果能达到十条一样的颜色 印刷：选用网目为250- 400目，丝印。 表干及实干时间：表干时间自然挥发5-10分钟；实干时间在24小时以内，如需快速干燥请烘烤80度10分钟为最佳效果。 稀释及清洗： 783慢干开油水；同时可使用718洗网水清洗。 测试方法（完全干燥后）： 3M胶纸粘在画有百格的油墨表面，45度角迅速拉起不脱油。 使用方法： 1、使用前应充分搅拌，用后随时封闭； 2、搅拌时加开油水10-15%，稀释到印刷粘度； 3、网板塞网时可用洗网水清洗； 4、不得与其它类型油墨混合使用。 注意事项： 1、塑胶材料的外观相似，但可能会是不同的材料，客户需试印确定其符合要求后，再批量印刷； 2、在移印过程中，如出现拉丝或散开，可适当加入一些慢干膏即可。 3、环境温度过高，将会影响油墨原有质量； 4、根据气候变化，请远离火源，阴暗环境下存放。PET-9100 ink printing ink characteristics: mainly used in PET, PC, stickers PET, aluminized film produced material, it has high adhesion, high resistance to fold, dumb light can achieve the effect of article 10 of the same colour printing: choose the mesh is 250-400 mesh, screen printing. Table dry and work time: dry time table natural volatilize 5-10 minutes; Work in time within 24 hours, if need to rapid drying please baking 80 degrees for 10 minutes best effect. Dilution and cleaning: 783 slow oil and water do open; At the same time, you can use clean water to wash the nets 718. Test method (dry) : 3 M tape is stuck in the picture has the case of printing ink surface, 45 degree Angle quickly pull up not to take off oil. Method of use: 1, before the use should be fully mixing, after using closed at any time; 2 when the oil and water, stir number 10-15 � F � � dilution to printing viscosity; 3, sheet stuffed nets can be used when washing nets water cleaning; 4, not with other kinds of printing ink mixed use. Note: 1, the appearance of the plastic material similar, but may be different materials, the customer shall determine the ShiYin requirements after another, batch printing; 2, in moving printing process, such as a wire drawing or leave, can be appropriately to add some slow dry paste can. 3, environmental temperature is too high, will influence the original ink quality; 4, according to climate change, please away from fire, dark environment for.

免责声明：以上信息由会员自行提供，内容的真实性、准确性和合法性由发布会员负责。集萃丝印特印网对此不承担任何责任。

联系我的时候！请说明在集萃丝印特印网上看到的，我好做备案！